Is there anyway to run EIM on intel machines until Tesla comeas out, i know this might seem stupid but i will like to be able to run modeler.
Thanks

Only if you are running 10.4.11 on the MacTel. If you are running 10.5, it probably won’t work correctly.  10.5 does not like older, CFM applications.

When i insert the CD it doesnt recognize the installer.Is not supported by the system. and yes i am using 10.4.11

Turns out Ed was trying to use modeler 3 from the 2.9 CD on the Mactel

Oh really, did it work? I am trying to get into modeler now that tesla is coming out soon.  How did you get it to work could i get the dongle from you guys or i will just wait for Tesla. Gosh i cant wait though,thanks Mat

I have been running Modeler v4 on an Intel iMac with 10.5.2 with only a few problems.  It doesn’t like Spaces very much, it also crashed constantly until I turned off Tooltips.  The rulers also don’t display correctly, aside from that, seems to work real well for a lot of the modeling I am doing.

_mike

Really, ok so did you purchased a new dongle from EITG and that will keep you running the modeler? or how did you work around the dongle thing? I dont mind about some of the minor artifacts.i just want to use the get to know again modeller to give it a try. It sucks that it doesnt work as well on intel machines that is one thing i alwys mistake for. I got a MacBook Pro and the software doesnt run perfect. Ok let me know dude.

Same dongle I use for Animator (Duo).  I didn’t expect it to work, but it seem to be OK.

_mike